Here is the monday (no work on president's day) update.
Head off the old bad compression motor.

another better pic

Valve cover off donor motor. Yes it is that clean in there..

another pic

Prepped the block for gasket prep spray. Like my little cardboard cutouts to fill holes in block?

Head plate with new gaskets in place.

Head plate on, head back on with ARP studs.

How it looks now. Still have to torque the nuts on studs because I need to buy a new 1/2" drive to 3/8" drive adapter for torque wrench.

I also put my new water pipe on and torqued the manifolds on. Tomorrow if I get time I am going to swap oilpans, oil cooer, and oil filter housing and torque them bolts. Then I need to put accessories on and swap the crank pulleys.